![]() ![]() ![]() Once the knot is tight you can exert tremendous tension on the rope by using the rod/marlinespike as a handle and pulling down with it.Ĥ. Now pull the knot tight around the rod by pulling on the working end assuming the standing end is secured and if not pull on both ends.ĥ. You will be going over the right side of the loop, under the center line, and then over the left side.Ĥ. Hold the lines in place and take your marlinespike, rod or other long cylindrical object and slide it into the knot from the right side. Grasp the lower side of the loop and fold it up and over the top part of the loop such that it will lay on top of the standing line with the standing line centered in the new loop formed.ģ. Form an overhand loop in the rope with the working or tag end of the rope on top of the standing part.Ģ. Marlinespike Hitch Knot Tying Instructionsġ. The knot is commonly used in rigging hammock suspension systems and "whoopie slings". The load that is put on the rods (or whatever is being used as the marlinspike) should only be from the standing side of the knot. The knot can also be tied in a series of parallel knots down two side-by-side ropes with rods attached through both knots to be used as a makeshift ladder. The marlinespike (or rod, stick, tool handle or any long and thin object) that has been inserted into the knot can be used as a handle to pull very hard on the rope. The marlinespike hitch is a rope knot that is often used with a rope that is already attached at one end to something in order to gain better purchase or grip on the rope for tightening. This is especially troublesome if the rod is not tapered.Home Rope Knots Marlinspike Hitch Marlinspike Hitch While this form may still hold when the standing part is subsequently loaded, it can jam badly against the rod. If the working end is loaded rather than the standing part, the knot will capsize into an overhand noose. In actual use the hitch should be loaded only from the standing side. That is, pass the rod over the near side of the loop, under the standing part and then over the far side of the loop.īefore tensioning, excess slack can be removed by pulling simultaneously on both the working and standing parts. Use the rod to snag a bight of the standing part through the loop. In stiffer material the first two steps can be accomplished in a single motion by twisting the working part with the fingers until a loop forms and flops over the standing part. ![]() That is, a loop which the working part passes over the standing part.įold the loop over the working part, towards the standing part such that the standing part is visible through the center of the loop. The knot can also be made by using the rod itself to form the loop, but the tying method does not affect the performance of the resulting hitch.īegin with an overhand loop. The hitch is frequently used by hammock campers to attach whoopie slings to tree huggers. When it does capsize into a traditional noose it can jam against the rod, making it much more difficult to release. Topologically it is a form of the noose, but in practice this hitch is not allowed to collapse into that shape. The advantages of this hitch over others which might serve the purpose are its quickness of tying and ease of releasing. As the name suggests, the type of rod traditionally used with this hitch is a marlinespike. It is useful when tightening knots and for other purposes in ropework. This allows more tension than could be produced comfortably by gripping the rope with the hands alone. The marlinespike hitch is a temporary knot used to attach a rod to a rope in order to form a handle. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |